User Manual UMN:CLI
V8102
823
To delete the T-CONT ID, use the following command.
Deletes the configured T-CONT ID.
13.4.4.1 GEM Port Configuration
To specify the GEM ports (priority queue) per T-CONT by mapping between T-CONT and
GEM port, use the following command.
gemport GEM-PORTS [queue
<0-7>]
Specifies the priority queues of a GEM port.
GEM-PORTS: mapper ID/GEM port ID
(ex: 1/1= mapper #1:gem port 1, 1/2= mapper#1:gem
port 2, 2/1-4=mapper #2:all gem ports)
Deletes the configured mapping between T-CONT and
the list of GEM ports.
13.4.4.2 Configuration of Weight on WRR Scheduling
To specify the weight value to queue number on WRR scheduling mode, use the following
command.
queue <1-8> weight <1-255>
Specifies the weight value to queue number on WRR
scheduling mode.
1-8: queue number (a lower number indicates a higher
priority.)
1-255: weight value
13.4.4.3 DBA Profile Association
You can associate a configured DBA profile with T-CONT by using the following command.
Associates a configured DBA profile with T-CONT.
NAME: DBA profile name
For the details of how to create and configure a DBA profile, see 13.5 DBA Profile.
To Next Page
Loading...