5-30 Adjustments
3. Press the Up or Down arrow to scroll to the parameter to change and press
the Enter key. The image below shows the submenu options under the
configuration menu.
4. To switch between a DHCP assigned IP Address and a Static IP Address, use
the Up or Down arrow to select the protocol and press the Enter Key. To
apply the changes, press the Enter key again.
• If DHCP is selected, the printer will reboot when Apply/Restart is
selected.
• If DHCP is selected, the IP Addresses submenu will no longer be visible.
• If Static IP is selected, you will automatically be brought into the
IP Addresses submenu before the printer reboots.
To Next Page
Loading...
