CP60 and CP60 Plus Service Manual 6-53
Platen Roller
Removal Procedure
1. Unplug the printer.
2. Remove the ribbon cartridge and cleaning roller.
3. Remove the
Main Enclosure (p. 6-8).
4. Remove the
Transport Timing Belt (p. 6-36).
5. Grasp the manual advance knob on the platen roller and lift the roller up and
out through the side wall of the transport chassis.
Replacement Notes
• If reusing the roller, clean the rubber with isopropanol and wipe off the
original grease from the shaft.
• Make sure the washer is between the platen roller and the transport chassis.
• Put a thin film of Molykote
®
DX grease (Part No. 807421-001) on the shaft at
the locations shown.
• Print several test cards to check print quality.
To Next Page
Loading...
