DataCard CP60 - YMC, K, T, and F Power and Base Power; Duplex Infeed Offset

5-14 Adjustments
YMC, K, T, and F Power and Base Power
These settings control the print threshold of each of the print panels. K and T
power settings can be made in the print driver, but YMC and F power can be
modified only from Diagnostics.
Power and Base Power serve the same function. The Base power setting is used
to compensate for variations in the printer, and the Power setting is used to tune
the printing results to suit the needs of the user (YMC=Yellow, Magenta, Cyan;
K=Black; T=Topcoat; F=Fluorescent).
Range
-100 to 100
Value Too Low Colors will be dull and washed out. K-panel printing may
have dropouts.
Value Too High
Frequent ribbon breaks and bar code growth.
Duplex Infeed Offset
This parameter controls how far a card will travel after it leaves the duplex entry
sensor. If this value is incorrectly set, the card may bind as the duplex rotates.
Range
1 to 80
Increase Value
The card travels further into the duplex.
Decrease Value
The card travels less distance into the duplex.