CP60 and CP60 Plus Service Manual 5-7
Option Purpose
Printer | Motor Tests
This option allows you to operate each of the motors in the
printer for a specified duration as described in
Testing Motors.
Printer | Motor Cycle Tests
This option is for selecting a motor to test by having it complete
a full cycle of operation as described in
Testing Motor Functions.
Printer | Step Test
This option runs routines from the printer’s firmware. Each routine
can be run individually or as a series of successive routines as
described in
Setting Up Step Tests for the Printer.
Magnetic Stripe | Test Card
This option provides access to printing test cards for the
magnetic stripe module. Only Advanced Users can read cards.
Magnetic Stripe|Configuration
This option for configuring the magnetic stripe module is
available only to the Advanced User. It is for configuring Start
Sentinels, etc. as described in
Configuring the Magnetic Stripe.
Magnetic Stripe| Diagnostics
This option provides access to functions for troubleshooting the
magnetic stripe module.
Smart Card | Test Card
The smart card test is a built-in routine to simulate smart card
personalization. A card is picked from the hopper, personalized,
and transported to the smart card module. See additional
information in
Testing the Smart Card Option.
To Next Page
Loading...
