Chapter 5 Errors and Troubleshooting
208
AS-410M Auto Slide Preparation System
Error
code
On-screen message Possible cause Solution
7028
<Error Message>
Unit: Auto Trimming Unit
Part: Blade Mark Check
PC
Symptom:
Communication error
Save command busy state
・Confirm that the application is
running on the Auto Trimming PC.
・Confirm that the communication
cable between the system and PC
is connected.
7029
Save command response code error
7030
Save command response error
7031
Finish command response timeout
7032
Finish command busy state
7033
Finish command response code error
7034
Finish command response error
7035
Request busy state
7036
Request response code error
7037
Request response error
7050
<Error Message>
Unit: Blade Mark Check
Unit
Part: Blade Mark Check
PC
Symptom:
Communication error
Command receiving failure
7051
Ready command response timeout
7052
Ready command busy
7053
Ready command response code error
7054
Ready command response error
7055
Thick command response timeout
7056
Thick command busy
7057
Thick command response code error
7058
Thick command response error
7059
QC command response timeout
7060
QC command busy
7061
QC command response code error
7062
QC command response error
To Next Page
Loading...
Need help?
General