Chapter 3 - Preoperational Setup -
AS-410M Auto Slide Preparation System
77
3-16-2 Setting change of the cooler temperature
Follow the procedure below to change the temperature setting.
① Push and hold SET button for five seconds to go to the program mode.
② The 7 segment display switches to .
③ Push SET button again.
④ The display shows the current target setting temperature. Push button (raise) or push
button (lower) to display .
⑤ Push the button (raise) or the button (lower) again to display .
⑥ Then push SET button.
⑦ Change to the target temperature; to raise the temperature, to lower the temperature,
and change to 20℃.
⑧ Then, again push SET button to display ; the setting temperature is completed.
⑨After the completion of the temperature setting, push SET button and hold 5 seconds to display
The screen indication will switch to the current cooling temperature.
To Next Page
Loading...
Need help?
General