Chapter 3 - Preoperational Setup -
AS-410M Auto Slide Preparation System
83
3-19 Start-up and termination of the expansion package application
For the expansion package option with online mode, the sectioning information of each block is entered
into the Main Unit system through the ”System connecting Software”.
Therefore, the information of sectioning condition does not need to be entered in the system of the Main
Unit.
3-19-1 Start-up and log-in of the expansion package application
Double click the LK-400 icon on the desktop. The LK-400 Software starts.
Startup icon
The log-in screen will be displayed after the LK-400 application starts. Enter the pre-registered ID and
password to operate each mode.
Make sure to check that the LAN cable of the AS-410M and LK-400 PC is connected properly.
Enter the administer-authorized User ID and Password to register or change a user registration or dye
information; then click the Login button.
Login screen
Change the Password from the initial value as needed for security.
Ensure to keep a record and store the ID and Password in a safe place. The system
may not be able to start again without the information.
Initial value
User ID: admin
Password: pass
Administer authorization: Required
Note:
The Password is case-sensitive.
！ Caution
To Next Page
Loading...
Need help?
General