Chapter 2 - Installation -
AS-410M Auto Slide Preparation System
45
2-6 Connection of the Main Unit to the PC for auto trimming
When the System configuration includes the auto trimming option, the Main Unit of the System must be
connected to the supplied personal computer. Connect the COM port on the PC via the supplied RS-232C
cable to the communication connector (COM1) on the back of the Main Unit. Connect the cable to the
USB port 1 on the back of the Main Unit to the USB port on the PC. Connect the power cable of the PC
to a rated power outlet.
※ Port layout maybe different depending on the model.
Main Unit port
Option Cable PC port
USB1 Auto Trimming USB2.0 USB port
USB2
Blade mark check
detection
USB2.0 USB port
COM1 Auto Trimming Serial 9 pins (Straight) Serial port
COM2
Blade mark check
detection
Serial 9 pins (Cross) Serial port
LAN1
Expansion
package
LAN (Cross) CAT.5E or more Internal LAN port
Connect the USB port 1 on the
back of the Main Unit and USB
port on the PC via the supplied
USB cable.
Connect the COM port on the PC to
the communication connector
(COM1) on the back of the Main Unit
via the supplied RS-232C cable.
Auto Trimming and Blade Mark Check PC
Rear side
LK-400 PC expansion LAN
● Do not use any other cable than packaged accessory.
COM2 COM1 LAN1 USB1 USB2
！ Caution
USB1
COM2
Internet
LAN
USB2
COM1
To Next Page
Loading...
Need help?
General