EasyManuals Logo

DNS AS-410M User Manual

Default Icon
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #182 background imageLoading...
Page #182 background image
Chapter 4 -Operational Procedures-
182
AS-410M Auto Slide Preparation System
Table 4-14: Auto Trimming setting
4-20 Remote monitoring setting
Basic auto trimming setting
On-screen item Description
Setting range
Surface detection ratio
(Threshold) (%)
Size of tissue specimen on paraffin surface compared to the
entire tissue size.
1 to 99
1st Thickness
Thickness of 1st surface trimming per single sectioning.
3 to 30
2nd Thickness
Thickness of 2nd initial trimming per single sectioning.
3 to 30
Sample Size
Sample block surface size
Regular: 24×37mm to 16×16mm Small :15×15mm to under
Surface trimming (1
st
trimming) (μm)
Amount of rough-cutting before detecting entire tissue size. 0 to 999
Initial trimming (2
nd
trimming)
(μm)
Amount of rough-cutting before detecting tissue size on paraffin
surface.
1 to 999
Retry count
Limit number of retry-trimming.
1 to 99
Thickness
Thickness of surface trimming and initial trimming per single
sectioning.
2 to 30
Maximum volume (thickness)
Max. limit of thickness of rough-cutting during auto trimming
function.
Wait limit
When failing to reach criteria after auto trimming, the machine will
work as:
On: making tissue slides Off: skip slide making.
Trimming rate (%) The amount of additional trimming (
rough-cutting
) if the
surface detection ratio does not exceed the threshold.
The
rough-cutting volume is determined by the increased volume
(δ Threshold).
1 to 99
1 to 999
- 99 to 99
Humidification treatment
On-screen item Description
Setting range
Humidifying time
Humidification time period before measuring the tissue size on
paraffin surface.
0 to 999
Auto trimming manual check mode
On-screen item Description
Setting range
ON, OFF
ON: Processes all sample blocks. Then conducts sectioning of all
sample blocks. OFF: Select sample blocks for auto trimming and
sectioning.
Additional trimming (μm)
Amount of additional trimming after checking the image on the Auto
Surface Detection Application.
0 to 999
Blade Change
Number of sectioning per blade edge.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DNS AS-410M and is the answer not in the manual?

DNS AS-410M Specifications

General IconGeneral
BrandDNS
ModelAS-410M
CategoryIndustrial Equipment
LanguageEnglish