Dräger Infinity Vista - IBP Display, Transducer Setup, and Calibration

INVASIVE PRESSURE LABELS
VF6 Infinity Vista 14-3
Invasive Pressure Labels
STEPS: Selecting the Invasive Pressure Label
1. Click on the IBP1 parameter box.
2. Click on
Label.
3. Select the appropriate pressure label for your monitoring session and click the
knob.
IBP Display
The monitor measures pressure in millimeters of mercury (mmHg) or kilo pascals
(kPa), and can display up to two pressure waveforms in the lower display channels.
The pressure parameter boxes show the following information:
z Parameter label (e.g., ART).
z Systolic pressure value (e.g., 125).
z Diastolic pressure value (e.g., 85).
z Mean pressure value (e.g., 102).
z A crossed bell if invasive pressure alarms are turned off.
If the second invasive pressure option is enabled, the second invasive blood pressure
has its own parameter box.