ASSIGNING NETWORK RECORDERS
VF6 Infinity Vista 7-5
Assigning Network Recorders
For monitors in the Infinity network, you can choose a primary and secondary
recorder/laser printer within the network. The monitor sends a recording request first
to the primary recording device. If that device is busy or unavailable (i.e. out of
paper), the monitor sends the request to the secondary recording device. If no
recording device is available, the monitor stores the recording (see the section Stored
Recordings in this chapter).
STEPS: Assigning Network Recording Devices
1. Press the Menu fixed key.
2. Click on
Monitor Setup.
3. Click on
Recordings.
4. Click on
Primary Recorder, select the desired recorder/printer and click the
knob again.
5. Click on
Secondary Recorder, select a secondary recorder/printer, if
available, and click the knob again.
NOTE:
z R50 Series recorders and laser printers in a wireless network are identified in
the menu by the device label assigned to them during network configuration.
z The Infinity network supports only one laser printer.
To Next Page
Loading...
