STARTING THE MONITOR
VF6 Infinity Vista 2-9
Starting the Monitor
1. Press the Power fixed key. The green light indicator in the key lights up and
the monitor emits 2 short tones.
2. Wait until the main screen appears at the end of the self-tests.
NOTE:
z If an internal failure or error should occur, the monitor’s screen turns blank. If
this should happen, turn the monitor off, then on again. In case of persistent
failure, remove the monitor from service and call your Biomed technician.
z Do not use the monitor if you do not have an AC Adapter or a fully charged
battery. Call your Biomed if you are not familiar with the use of the battery or
the power adapter.
Monitor connected to MultiMed
To Next Page
Loading...
