MESSAGES
VF6 Infinity Vista 5-13
Messages
The monitor displays the following types of messages:
z Alarm messages to alert you to a physiological condition (e.g., Asystole).
z Status messages to alert you to faults and their causes (e.g., RA Lead Off) or to
follow the work-in-progress of your monitor (e.g., Alarm Recording Started).
z Diagnostic messages to alert you to hardware and software conditions (e.g.,
Low Battery Reset).
z Network messages (including Alarm Group messages) to alert you to network
operating conditions (also see the chapter Network Applications).
The monitor displays alarm messages according to their alarm grade on a red, yellow
or white background in the message area (e.g., Asystole) and in the parameter box
(e.g., ASY).
The monitor displays status and network messages in the message area at the bottom
of the screen.
Diagnostic messages appear during the self-test routines that occur immediately after
you turn the monitor on.
Alarm and most status and network messages appear alternately until the condition
has been resolved. Diagnostic messages and some status and network messages
appear only once.
Whenever possible, Dräger recommends that you check the equipment and the
accessories carefully before monitoring your patient to eliminate faulty conditions.
Careful patient preparation also eliminates most common error conditions.
WARNING: Do not operate the monitor if you detect any
equipment malfunction. In this case, take the unit out of
operation and call your Biomed or DrägerService.
To Next Page
Loading...
