C-2 Infinity Vista VF6
C DEFAULT SETTINGS AND BIOMEDICAL SUPPORT
Default Settings
The first section of this appendix list the default settings for the monitor. These
settings are programmed into the monitor as you receive it from the factory, and are
used by the monitor until the user changes them. The first three columns in the
following table show these settings for adult, pediatric, and neonatal monitoring
modes.
After discharging a patient to admit a new patient, most settings, called patient
settings, are remembered by the monitor while others return to their factory defaults.
If the user chooses to save the current patient setup, many factory settings are changed
to patient settings, and is active for the next patient of that category. Whether or not a
setting returns to its factory default between patients or can be saved as a monitoring
configuration is noted in the following table.
NOTE:
z Alarm Limits, Alarm On/Off, and Record On/Off settings are considered
Patient Settings for all parameters except where noted.
z Some settings are for optional features and are only available on units with
these options installed or enabled.
To Next Page
Loading...
