Dräger Infinity Vista - Page 266

D-16 Infinity Vista VF6
D TECHNICAL DATA
Electromagnetic Emissions
Emissions Compliance according to... Electromagnetic environment
RF emissions (CISPR 11) Group 1 The equipment uses RF energy
only for its internal function.
Therefore, its RF emissions are
very low and are not likely to cause
any interference in nearby
electronic equipment.*
CISPR Emissions Classification Class B The equipment is suitable for use
in all establishments including
domestic establishments and those
directly connected to the public
low-voltage power supply network
that supplies buildings used for
domestic purposes.
Harmonic emissions
(IEC 61000-3-2)
Class A
Voltage fluctuations / flicker (IEC
61000-3-3)
Complies
*Note that when used with the wireless options, the monitor emits electromagnetic energy in order to
communicate with the Infinity Network. Nearby electronic equipment may be affected. Radio frequency
characteristics are specified above. See the documentation that accompanies the wireless products for further
details.
Electromagnetic Immunity
Immunity against... IEC 60601-1-2 test level
Compliance
level (of this
device)
Electromagnetic environment
electrostatic discharge,
ESD
(IEC 61000-4-2)
contact discharge: r 6 kV
air discharge:
r 8 kV
r 6 kV
r 8 kV
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be kept at levels to
reduce electrostatic charge to
suitable levels.
electrical fast transients
/ bursts
(IEC 61000-4-4)
power supply lines: r 2 kV
longer input / output lines:
r 1 kV
r 2 kV
r 1 kV
Mains power quality should be that
of a typical commercial or hospital
environment.
surges on AC mains
lines
(IEC 61000-4-5)
Common mode: r 2 kV
differential mode:
r 1 kV
r 2 kV
r 1 kV
Mains power quality should be that
of a typical commercial or hospital
environment.
power frequency
magnetic field 50/60 Hz
(IEC 61000-4-8)
3 A/m 3 A/m Equipment which emits high levels
of power line magnetic fields (in
excess of 3A/m) should be kept at a
distance to reduce the likelihood of
interference.