a
Aim the remote control at the target projector and press the [ID] button.
e current Projector ID is displayed on the projected screen. It
dis
appears aer about 3 seconds.
b
While holding the [ID] button, press the number button that matches the
ID o
f th
e projector you want to operate.
e projector you want to operate is selected.
•
When y
ou select [0/All] on the remote control, you can operate
all projectors regardless the Projector ID setting.
•
When you set the Projector ID setting to O, you can operate
the projector using the remote control whichever ID you select
on the remote control.
•
e projector ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and
so on, the saved ID setting is retained. However, if the batteries
are le out of the remote control for an extended period, the ID
returns to its default setting ( 0/All).
•
When you use multiple remote controls at the same time, you
may not be able to operate projectors as intended due to infrared
interference.
Adjusting Color Uniformity
If the color tone of the image is uneven, you can adjust the color tone balance.
A
d
j
ust the Color Uniformity setting for each projector.
e color tone may not be uniform even aer adjusting the color
unifo
rmity.
Using Multiple Projectors
119
To Next Page
Loading...
