Epson EB-810E - Setting up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management
Pro
tocol) soware on network computers so they can monitor projectors.
If your network uses this soware, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the Net
work menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Se
lect the Projector Control menu and press [Enter].
d
Set the S
NMP setting to On.
e
If n
o SNMP Comm
unity Name has been set, a screen prompting you to
set a Community Name is displayed. Enter an SNMP Community Name.
You can enter up to 32 alphanumeric characters.
f
Enter up to two IP addresses to receive SNMP n
ot
ications as the Trap IP
Address 1 and Trap IP Address 2 settings, using 0 to 255 for each address
eld.
Do not use these addresses: 224.0.0.0 through 255.255.255.255. is
pr
ojector supports SNMP agent version 1 (SNMPv1).
g
When you nish
selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
Setting Up Monitoring Using SNMP
177