Epson EB-810E - Updating the Firmware

When you select the Firmwar
e Update option in the projector's Initial/All
Settings menu, the projector enters rmware update mode and is ready to
perform a rmware update using the USB-A or USB-B port.
You can also update the projector's rmware over the network using the Epson
Projector Management soware. See the Epson Projector Management Operation
Guide for instructions.
g
Related Links
•
"Updating Firmware Using a USB Storage Device" p.239
•
"Updating Firmware Using a Computer and USB Cable" p.240
Updating Firmware Using a USB Storage Device
You can update the projector's rmware using a USB storage device.
Responsibility for updating the rmwar
e lies with the customer. If a
rmware update fails due to problems such as a power failure or
communication problems, a fee will be charged for any necessary repairs.
a
Download the projector r
mwar
e le from the Epson Web site.
b
Copy the downloaded rmwar
e le to the root folder (highest folder in the
hierarchy) of the USB storage device.
•
e USB st
orage device must be formatted in FAT format.
•
Do not copy any other les to the USB storage device.
•
Do not change the rmware's le name. If the le name is
changed, the rmware update will not start.
•
Check that the rmware le you copied is the correct le for your
projector model. If the rmware le is not correct, the rmware
update will not start.
c
Connect the USB storage device to the projector's USB-A port.
•
Conn
ect the USB storage device directly to the projector. If the
USB storage device is connected using a USB hub, the rmware
update may not be applied correctly.
d
Press the [Menu] button, select the I
nit
ial/All Settings menu, and press
[Enter].
e
Select F
irmware Update and press [Enter].
Updating the Firmware
239