Epson EB-810E - Projecting with the Wireless Presentation System

d
Select Yes to set Connection Guide Display to On if necessary.
•
We re
commend selecting Yes. e next time you turn on the
projector and no signal is being input, the connection guide
for the wireless transmitter (Epson Wireless Presentation) is
displayed.
•
e message prompting you to set Connection Guide Display to
On is displayed when Connection Guide Display is set to O
and Content Playback is set to O.
•
You can change the connection guide display from the projector's
Network menu.
s Network > Transmitter Settings > Connection Guide
Display
e
Remove the wireless transmitter from the projector and insert the wireless
L
AN mo
dule into the same port used for the wireless transmitter.
f
Press the [Menu] button on the control panel or remote control.
g
Make sure W
ire
less LAN Power is set to On in the projector's
Management menu and Simple AP is set to On in the projector's
Network Settings menu.
We recommend turning the projector o and then back on to enable the
connection guide display.
If you set the Aut
o Power On setting to On in the projector's Network
menu, you can start projection even if the projector is in standby mode
(when the power is o).
s Network > Transmitter Settings > Auto Power On
Projecting with the Wireless Presentation System
You c
an use the paired wireless transmitter to quickly establish direct
connection between the projector (receiver) and Windows/Mac computers and
easily project your images.
Make sure the wireless LAN module is installed into your projector.
a
Turn on the projector.
b
Connect the wireless transmitter to a USB port on your computer.
c
Project your content with the Epson Wireless Presentation s
owar
e in
the wireless transmitter. See the Epson Wireless Presentation System User's
Guide for details.
Wireless Network Projection
153