Epson EB-810E - Correcting Image Shape with Point Correction

If you see this screen, you cannot adjust the shape any further in the
direc
tion indicated by the gray triangle.
i
Repeat steps 7 and 8 as needed to adjust any remaining corners.
j
When you are ni
sh
ed, press [Esc].
•
Y
o
u c
an ne tune the corrected results. Use Quick Corner to adjust the
tilt of the image, and then use Point Correction for ne tuning. Select
Quick Corner or Point Correction on the screen in step 6.
•
To save the current shape of an image you have adjusted, select Save
Memory. You can save up to three image shapes in the memory.
s Installation > Geometry Correction > Memory > Save Memory
•
To reset the Arc Correction settings, hold down [Esc] for about 2
seconds while the area selection screen is displayed, and then select Yes.
g
Related Links
•
"Co
rrecting the Image Shape with Quick Corner" p.62
•
"Correcting Image Shape with Point Correction" p.67
Correcting Image Shape with Point Correction
You can use the projector's Point Correction setting to ne-tune the image
shape in portions of an image. e image is divided into a grid which allows you
to move intersection points on the grid as necessary to correct distortion.
If you change the Scre
en Type and Screen Position settings, the
adjustments are reset.
a
Turn on the projector and display an image.
b
Press the [Menu] button on the control panel or remote control.
Image Shape
67