Epson EB-810E - Precautions on Installation

Front/Rear
Front Upside Down/Rear Upside Down
Select the correct Pro
jection option in the projector's Installation menu
according to the installation method being used. If necessary, turn on the Inv
Direction Button setting in the projector's Operation menu and adjust the
Menu Rotation setting in the projector's Display menu.
•
e default
Projection setting is Front.
•
You can change the Projection setting as follows by pressing down the
[A/V Mute] button on the remote control for about 5 seconds.
•
Switch Front to/from Front/Upside Down
•
Switch Rear to/from Rear/Upside Down
g
Related Links
•
"Pr
ojection Modes" p.52
Precautions on Installation
Attention
•
If the projector is installed at an angle, it should be installed by qualied
technicians using mounting hardware designed for use with this projector.
•
Install the projector appropriately to prevent it from falling down.
•
Use M4 screws (up to a depth of 9 mm) to secure the projector's xing points, or
VESA mount xing points, to the mounting hardware at four points.
Projector Placement
26