Epson EB-810E - Wired Network Projection

You can send images to your projector through a wired network. To do this,
conne
ct the projector to your network, and then set up your projector and
computer for network projection.
Aer connecting and setting up the projector as described here, download and
install Epson iProjection (Windows/Mac) from the following Web site.
epson.sn
Epson iProjection soware sets up your computer for network projection. It also
allows you to hold interactive meetings by projecting user's computer screens
over a network. See the Epson iProjection Operation Guide (Windows/Mac) for
instructions.
If the Web Control Password has not been set, a screen prompting you to
set a p
assword is displayed when you save the network settings. Follow the
on-screen instructions to set the password.
g
Related Links
•
"Co
nnecting to a Wired Network" p.137
•
"Selecting Wired Network Settings" p.137
Connecting to a Wired Network
To connect the projector to a wired local area network (LAN), use a 100Base-TX
or 10Bas
e-T network cable. To ensure proper data transmission, use a Category
5 shielded cable or better.
a
Connect one end of the network cable to your network hub, switch, or
rou
ter.
b
Connect the other end of the cable to the projector's LAN port.
Selecting Wired Network Settings
Before you can project from computers on your network, you need to select
netw
ork settings on the projector.
Make sure you already connected the projector to your wired network
using the LAN port.
Wired Network Projection
137