Check the solutions in these sections if you have problems operating the
pro
jector or remote control.
g
Related Links
•
"Solutions to Projector Power or Shut-O Problems" p.253
•
"Solutions to Problems with the Remote Control" p.253
•
"Solutions to Password Problems" p.254
•
"Solution When "e Battery that Saves Your Clock Settings is Running Low"
Message Appears" p.254
Solutions to Projector Power or Shut-O Problems
If the projector does not turn on when you press the power button or it turns o
unexpectedly, try the following solutions:
•
Make sure the power cord is securely connected to the projector and to a
working electrical outlet.
•
If the power button on the remote control does not turn on the projector,
check its batteries and make sure at least one of the remote receivers are
available in the Remote Receiver setting in the projector's Installation menu.
•
e projector's buttons may be locked for security. Unlock the buttons in the
Control Panel Lock setting in the projector's Management menu or use the
remote control to turn on the projector.
•
If the projector's light source turns o unexpectedly, it may have entered
sleep mode aer a period of inactivity. Perform any operation to wake the
projector. To turn o sleep mode, set the Sleep Mode setting to O in the
projector's Operation menu.
•
If the projector turns o unexpectedly, the A/V mute timer may be enabled.
Set the A/V Mute Timer setting to O in the projector's Operation menu.
•
If the projector's light source turns o, the status indicator is ashing, and the
temp (temperature) indicator is lit, the projector has overheated and turned
o.
•
e coolin
g fans may run in standby status depending on the projector
settings. Also, when the projector wakes from standby status, the fans may
cause an unexpected noise. is is not a malfunction.
•
e power cord may be defective. Disconnect the cord and contact Epson for
help.
g
Related Links
•
"Unlocking the Projector's Buttons" p.134
•
"Projector Administration Settings - Management Menu" p.204
•
"Projector Feature Settings - Operation Menu" p.200
•
"Projector Installation Settings - Installation Menu" p.195
Solutions to Problems with the Remote Control
If the projector does not respond to remote control commands, try the following
solutions:
•
Check that the remote control batteries are installed correctly and have
power. If necessary, replace the batteries.
•
Make sure you are operating the remote control within the reception angle
and range of the projector.
•
Make sure the projector is not warming up or shutting down.
•
Check to see if a button on the remote control is stuck down, causing it to
enter sleep mode. Release the button to wake the remote control up.
•
Strong uorescent lighting, direct sunlight, or infrared device signals may be
interfering with the projector's remote receivers. Dim the lights or move the
projector away from the sun or interfering equipment.
•
Make sure at least one of the remote receivers are available in the Remote
Receiver setting in the projector's Installation menu.
•
If the Remote Receiver setting is disabled, hold down the [Menu] button on
the remote control for at least 15 seconds to reset the setting to its default.
Solving Projector or Remote Control Operation Problems
253
To Next Page
Loading...
