Epson EB-810E - Batch Setup Error Notification

f
Eject the USB device (Windows) or drag the removable disk icon to the
Trash (M
ac).
g
Disconnect the USB cable.
e pro
jector turns o.
h
Disconnect the power cord from the projector to which you want to copy
sett
ings, and check that all of the projector's indicators have turned o.
i
Connect the USB cable to the computer's USB port and to the projector's
USB-B po
rt.
j
Hold down the [Menu] button on the remote control or the control panel
and conn
ect the power cord to the projector.
k
When all of the projector's indicators turn on, release the [Menu] button.
e comp
uter recognizes the projector as a removable disk.
l
Copy the batch setup le (PJCO
NFDATA.bin) that you saved to your
computer to the top level folder of the removable disk.
Do not copy any les or fo
lders other than the batch setup le to the
removable disk.
m
Eject the USB device (Windows) or drag the removable disk icon to the
T
rash (M
ac).
n
Disconnect the USB cable.
When al
l of the indicators start ashing, the settings are being written.
When writing is nished, the projector turns o.
Caution
Do no
t disconnect the power cord from the projector while the le is being
written. If the power cord is disconnected, the projector may not start
correctly.
g
Related Links
•
"Bat
ch Setup Error Notication" p.226
Batch Setup Error Notication
e
projector's indicators notify you if an error occurs during a batch setup
operation. Check the status of the projector's indicators and follow the
instructions described in the table here.
Indicator status Problem and solutions
•
Laser
: Orange - ashing
fast
•
Temp: Orange - ashing
fast
e batch setup le may be corrupt, or the USB ash
drive may not be connected correctly.
Disconnect the USB ash drive, unplug and then plug in
the projector's power cord, and then try again.
•
Pow
er: Blue - ashing
fast
•
Status: Blue - ashing
fast
•
Laser: Orange - ashing
fast
•
Temp: Orange - ashing
fast
Writing the settings may have failed and an error may
have occurred in the projector's rmware.
Stop using the projector, remove the power plug from
the electrical outlet. Contact Epson for help.
Copying Menu Settings Between Projectors (Batch Setup)
226