Epson EB-810E - Displaying from a Mac Laptop; Solutions When Not Supported Message Appears; Solutions When Only a Partial Image Appears; Related Links

c
If necessary, check your video card settings and set the multiple display
opt
ion to Mirror or Duplicate.
Displaying From a Mac Laptop
If th
e message No Signal is displayed when projecting from a Mac laptop, you
need to set up the laptop for mirrored display. (See your laptop manual for
details.)
a
Open the System Preferences utility and select Displays.
b
Se
lect the Displ
ay or Color LCD option, if necessary.
c
Click the Arrange or Arrangement tab.
d
Se
lect Mirror Displays.
Solutions W
hen "Not Supported" Message Appears
If the message Not s
upported is displayed, try the following solutions:
•
Make sure the correct input signal is selected in the projector's Signal I/O
menu.
•
Make sure the computer's display resolution does not exceed the projector's
resolution and frequency limits. If necessary, select a dierent display
resolution for your computer.
•
If you are projecting from an HDMI source, change the HDMI IN EQ Level
setting in the projector's Signal I/O menu. Aer changing the setting, you
may need to restart the projector. Follow the on-screen instructions.
•
If you are projecting using a thumb-sized media streaming device, set the
HDMI IN EQ Level setting to Auto in the projector's Signal I/O menu. If a
problem occurs, change the setting.
g
Relat
ed Links
•
"I
n
put Signal Settings - Signal I/O Menu" p.192
•
"Supported Monitor Display Resolutions" p.266
Solutions When Only a Partial Image Appears
If only a partial computer image appears, try the following solutions:
•
Make sure you selected the correct Screen Type setting in the projector's
Installation menu for the screen you are using.
If there are margins between the edge of the image and the projected screen
frame, adjust the position of the image.
•
Make sure the Scale setting is turned o in the projector's Image menu.
•
If you have adjusted the image size using the Digital Zoom setting in the
projector's Installation menu, perform Image Shi to adjust the image
position.
s Installation > Digital Zoom > Image Shi
•
Press the [Aspect] button on the remote control to select a dierent image
aspect ratio.
•
If you zoomed into or out of the image using the [E-Zoom] buttons, press the
[Esc] button until the projector returns to a full display.
•
Check your computer display settings to disable dual display and set the
resolution within the projector's limits.
•
Check the resolution assigned to your presentation les to see if they are
created for a dierent resolution.
•
When projecting in Content Playback mode, make sure you are using the
appropriate Overlay Eect settings.
s Operation > Content Playback > Overlay Eect
•
Make sure you selected the correct Projection setting in the projector's
Installation menu.
Solving Image or Sound Problems
249