Turn o the projector aer use.
•
Turn
o this product when it is not in use to prolong the life of the
projector. Light source life varies depending on the mode selected,
environmental conditions, and usage. Brightness decreases over time.
•
If the Light Source Calibration setting is set to Run Periodically
in the projector's Management menu, light source calibration starts
automatically if you turn o the projector and the following conditions
are present:
•
100 hours have passed since the last light source calibration
•
You have used the projector continuously for more than 20 minutes
•
Since the projector supports the direct shutdown feature, it can be
turned o directly using the breaker.
a
Press the power button on the control panel or remote control.
e pro
jector displays a shutdown conrmation screen.
b
Press the power button again. (To leave it on, press any other button.)
e p
ro
jector beeps twice, the light source turns o, and the status
indicator turns o.
c
To transport or store the projector, make sure the power indicator is blue
(b
u
t n
ot ashing) and the status indicator is o, then unplug the power
cord.
Turning O the Projector
47
To Next Page
Loading...
