g
Related Links
•
"Pr
ojector Installation Settings - Installation Menu" p.195
•
"Adjusting the Image Position Using Screen Position" p.55
•
"Image Quality Settings - Image Menu" p.190
•
"Supported Monitor Display Resolutions" p.266
•
"Adding Eects to Your Projected Image" p.106
Solutions When the Image is not Rectangular
If the projected image is not evenly rectangular, try the following solutions:
•
Place the projector directly in front of the center of the screen, facing it
squarely, if possible.
•
Adjust the Quick Corner setting to correct the image shape.
s Installation > Geometry Correction > Quick Corner
•
Adjust the Arc Correction setting to correct the image shape projected on a
curved surface.
s Installation > Geometry Correction > Arc Correction
•
Adjust the Point Correction setting to correct slight distortion which occurs
partially.
s Installation > Geometry Correction > Point Correction
g
Related Links
•
"Correcting the Image Shape with Quick Corner" p.62
•
"Correcting Image Shape with Arc Correction" p.65
•
"Correcting Image Shape with Point Correction" p.67
Solutions When the Image Contains Noise or Static
If the projected image contains electronic interference (noise) or static, try the
fol
lowing solutions:
•
Che
ck the cables connecting your computer or video source to the projector.
ey should be:
•
Separated from the power cord to prevent interference
•
Securely connected at both ends
•
Not connected to an extension cable
•
Adjust the Noise Reduction and MPEG Noise Reduction settings in the
projector's Image menu.
s Image > Image Enhancement > Noise Reduction
s Image > Image Enhancement > MPEG Noise Reduction
•
Select a computer video resolution and refresh rate that are compatible with
the projector.
•
If you adjusted the image shape using the projector controls, try decreasing
the Sharpness setting in the projector's Image menu to improve image
quality.
•
If you connected an extension power cable, try projecting without it to see if
it caused interference in the signal.
•
Make sure you selected the correct EDID setting in the projector's Signal I/O
menu, if available for your image source.
•
If you are using the USB Display function, turn o the Transfer layered
window setting in the Epson USB Display Settings program on your
computer.
g
Related Links
•
"Image Quality Settings - Image Menu" p.190
•
"Supported Monitor Display Resolutions" p.266
•
"Input Signal Settings - Signal I/O Menu" p.192
Solutions When the Image is Fuzzy or Blurry
If the projected image is fuzzy or blurry, try the following solutions:
Solving Image or Sound Problems
250
To Next Page
Loading...
