Be sure to keep the remote control in a safe place; if you lose it, you will
not b
e able to enter the password.
Entering a Password to Use the Projector
When t
he password screen is displayed, enter the correct password.
a
Hold down the [Num] button on the remote control while you enter the
password using the numeric buttons.
e password screen closes.
b
If t
he password is incorrect, you see a message and a prompt to try again.
En
t
er t
he correct password to proceed.
Attention
•
If an inco
rrect password is entered three times in succession, the message
e projector's operation will be locked. is displayed for approximately
5 minutes, and the projector switches to standby mode. If this happens,
disconnect the power plug from the electrical outlet, reinsert it, and turn
the projector back on. e projector displays the password entry screen
again so that you can enter the correct password.
•
If you have forgotten the password, make a note of the " Request Code:
xxxxx" number that appears on the screen and contact Epson for help.
•
If you continue to repeat the above operation and input the wrong
password 30 times in succession, the message e projector's operation
will be locked. Contact Epson as described in your documentation. is
displayed and the projector does not accept any more password entries.
Contact Epson for help.
Locking the Projector's Buttons
You can lock the buttons on the control panel to prevent anyone from using the
projector. e projector can still be operated using the remote control.
Projector Security Features
133
To Next Page
Loading...
