Epson EB-810E - Copying Menu Settings Between Projectors (Batch Setup)

Aer selecting the projector's menu settings for one projector, you can use the
fo
llowing methods to copy the settings to other projectors, as long as they are
the same model.
•
by using a USB ash drive
•
by connecting a computer and projector using a USB cable
•
by using Epson Projector Management
You cannot copy any information unique to an individual projector, such as
Light Source Hours or Status.
•
Perf
orm batch setup before adjusting the image settings such as
keystone distortion correction. Since image adjustment values are
also copied to another projector, the adjustments you made before
performing the batch setup are overwritten and the projected screen
you adjusted may change.
•
When copying the menu settings from one projector to another, user's
logo is also copied. Do not register the information that you do not
want to share between multiple projectors as a user's logo.
•
Make sure Batch Setup Range is set to Limited if you do not want to
copy the following settings:
•
Password Protection settings
•
EDID in the Signal I/O menu
•
Network menu settings
s Management > Batch Setup Range
Caution
Epso
n takes no responsibility for batch setup failures and associated repair costs due
to power outages, communication errors, or other problems that may cause such
failures.
g
Related Links
•
"Tran
sferring Settings From a USB Flash Drive" p.224
•
"Transf
erring Settings From a Computer" p.225
Transferring Settings From a USB Flash Drive
You can copy menu settings from one projector to another of the same model
using a US
B ash drive.
•
e USB as
h drive must use a FAT 16/32 format and not incorporate
any security function. Delete any les on the drive before using it for
batch setup or the settings may not be saved correctly.
•
You can also use this batch setup method from the projector's menu.
a
Disconnect the power cord from the projector, and check that all of the
pro
jector's indicators have turned o.
b
Connect an empty USB ash dr
ive directly to the projector's USB-A port.
c
Hold down the [Esc] button on the remote control or the control panel
and conn
ect the power cord to the projector.
d
When all of the projector's indicators turn on, release the [Esc] button.
e indicat
ors start ashing and the batch setup le is written to the USB
ash drive. When writing is nished, the projector turns o.
Caution
D
o n
o
t disconnect the power cord or the USB ash drive from the projector
while the le is being written. If the power cord or USB ash drive is
disconnected, the projector may not start correctly.
Copying Menu Settings Between Projectors (Batch Setup)
224