You can set up the projector to send you an e-mail alert over the network if
ther
e is a problem with the projector.
If you set the Standby Mode setting to Communication On in the projector's
Operation menu, you can receive the e-mail alerts even if the projector is in
standby mode (when the power is o).
a
Press the [Menu] button, select the Net
work menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Se
lect the Mail Notication menu and press [Enter].
d
Set the Mail Notication setting to On.
e
Ent
er the IP address for the SMTP Se
rver option.
Do not use "127.x.x.x" (where x is a number from 0 to 255) for the
SMTP Se
rver.
f
Select a type of Authentication of SMTP server.
g
Select a number for the SMTP server Por
t Number, from 1 to 65535
(default is 25).
h
Enter a User Name for the SMTP server.
i
Ent
er a Password for the SMTP server authentication.
j
Ent
er the e-mail address to be indicated as the sender in Fro
m.
k
Choose an address eld,
enter the e-mail address, and select the alerts you
want to receive. Repeat for up to three addresses.
Your e-mail address can be up to 64 alphanumeric characters long.
l
When you ni
sh
selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
If a critical problem causes a projector to shut down, you may not receive
an e-m
ai
l aler
t.
g
Related Links
•
"Net
work Projector E-mail Alert Messages" p.176
Network Projector E-mail Alert Messages
When a problem occurs with a projector on the network, and you selected
to receive e-mail alerts, you receive an e-mail containing the following
information:
•
e email address set in From as the mail sender
•
Epson Projector in the subject line
•
e name of the projector experiencing a problem
•
e IP address of the aected projector
•
Detailed information about the problem
Setting Up Projector Network E-Mail Alerts
176
To Next Page
Loading...
