Epson EB-810E - Network Menu - Wired LAN Menu

Setting Options Description
Client Certicate — Im
ports the client certicate.
Setting is only displayed when EAP Type
is set to PEAP-TLS or EAP-TLS.
Verify Server
Cert
icate
On
O
Set to On to verify the server certicate
when a CA certicate has been set.
CA certicate — Im
ports the CA certicate.
RADIUS Server
Name
U
p to 64
alphanumeric
characters
Enter the server name to verify.
IP Settings DHCP
IP Addres
s
Subnet Mask
Gateway Address
Set DHCP to On if your network assigns
addresses automatically; set to O to
manually enter the network's IP Address,
Subnet Mask, and Gateway Address
using 0 to 255 for each address eld.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
DNS Server 1
DNS Ser
ver 2
Various IP
addresses
Enter the IP address for the DNS server,
using 0 to 255 for each address eld.
e DNS server resolves the host name.
Do not use the following IP addresses:
127.x.x.x (where x is a number from 0 to
255).
When these settings are not set
and remain as 0.0.0.0, DNS server
information is acquired using DHCP.
Aer acquiring the information, the
values remain as 0.0.0.0.
Setting Options Description
IPv6 On
O
Set to On if you wan
t to connect the
projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
Auto Conguration On
O
Set t
o On to assign addresses
automatically according to the Router
Advertisement.
Use Temporary
Addres
s
On
O
Set to On if you want to use a temporary
IPv6 address.
IP Address Display On
O
Set to On to display the IP address on the
net
work information screen and Home
screen.
Network Menu - Wired LAN Menu
Sett
ings on the Wired LAN menu let you select the wired LAN settings.
Setting Options Description
IP Settings DHCP
IP A
ddres
s
Subnet Mask
Gateway Address
Set DHCP to On if your network assigns
addresses automatically; set to O to
manually enter the network's IP Address,
Subnet Mask, and Gateway Address
using 0 to 255 for each address eld.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
Projector Network Settings - Network Menu
212