Epson EB-810E - Input Signal Settings - Signal I;O Menu

Setting Options Description
Dynamic Range Dynamic Range Changes the range of dark and bright
areas in im
ages; choose from Auto
(recommended), SDR, HDR10, or HLG.
Setting is only displayed in the following
cases:
•
Color Mode is not set to DICOM
SIM.
•
e current source is HDMI or
HDBaseT.
Signal Status Displays the detected input image signal.
HDR10 Setting Changes the PQ (Perceptual Quantizer)
curv
e of the dynamic range using the
HDR PQ method.
is setting is only displayed when
Dynamic Range is set to Auto and Signal
Status is HDR10, or when Dynamic
Range is set to HDR10.
HLG Setting Changes the HLG (Hybrid Log Gamma)
curv
e of the dynamic range using the
HDR HLG method.
is setting is only displayed when
Dynamic Range is set to Auto and Signal
Status is HLG, or when Dynamic Range
is set to HLG.
Reset to Defaults — Resets all settings for current input
sour
ce.
Setting Options Description
EDID EDID (HDMI1)
EDID (HDMI2)
ED
ID (HDBaseT)
Describes the display capabilities of
your projector. Change this setting as
necessary according to the resolution of
the image.
You can select the EDID settings
for individual input sources without
changing the input source.
HDMI IN EQ Level HDMI1
HDMI2
Ad
justs the HDMI input signal level
depending on the devices connected to
the HDMI port. If there is a lot of
interference in the image, or if a problem
such as no image being projected occurs,
change the setting.
You can select the settings for individual
input sources without changing the input
source.
A/V Output While Projecting
Always On
S
et to Always On to output audio from
the projector's speaker system when the
projector does not project any images.
Setting is only displayed in the following
cases:
•
Auto Power On is set to HDMI1 and
Power On Trigger is set to Plug-in
Detection.
•
Quick Startup is set to O in the
projector's Operation menu.
•
Auto Power On is set to O in the
projector's Network menu.
s Network > Transmitter Settings >
Auto Power On
Inverse Audio On
O
Set to On to invert the audio's le and
rig
ht channels to match the projector
installation position.
Input Signal Settings - Signal I/O Menu
193