Epson EB-810E - Transferring Settings from a Computer

e
Remove the USB ash dr
ive.
e le name for the batch setup le is PJCONFDATA.bin. If you
ne
ed to change the le name, add text aer PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the le name, the projector may not be able to recognize
the le correctly.
f
Disconnect the power cord from the projector to which you want to copy
s
ett
ings, and check that all of the projector's indicators have turned o.
g
Connect the USB ash dr
ive containing the saved batch setup le to the
projector's USB-A port.
h
Hold down the [Menu] button on the remote control or the control panel
and conn
ect the power cord to the projector.
i
When all of the projector's indicators turn on, release the [Menu] button.
(e indicat
ors remain on for approximately 75 seconds.)
When all of the indicators start ashing, the settings are being written.
When writing is nished, the projector turns o.
Caution
D
o n
o
t disconnect the power cord or the USB ash drive from the projector
while the le is being written. If the power cord or USB ash drive is
disconnected, the projector may not start correctly.
j
Remove the USB as
h
dr
ive.
Transferring Settings From a Computer
You can copy menu settings from one projector to another of the same model by
conne
cting the computer and projector with a USB cable.
•
You c
an use this batch setup method with the following operating
system versions:
•
Windows 10 and later
•
macOS 10.13.x and later
•
You can also use this batch setup method from the projector's menu.
a
Disconnect the power cord from the projector, and check that all of the
pro
jector's indicators have turned o.
b
Connect a USB cable to the computer's USB port and to the projector's
USB-B po
rt.
c
Hold down the [Esc] button on the remote control or the control panel
and conn
ect the power cord to the projector.
d
When all of the projector's indicators turn on, release the [Esc] button.
e comp
uter recognizes the projector as a removable disk.
e
Open the removable disk icon or folder, and save the batch setup le t
o t
h
e
computer.
e le name for the batch setup le is PJCONFDATA.bin. If you
ne
ed to change the le name, add text aer PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the le name, the projector may not be able to recognize
the le correctly.
Copying Menu Settings Between Projectors (Batch Setup)
225