You can save an image on the projector and display it whenever the projector
turn
s on. You can also display the image when the projector is not receiving an
input signal. is image is called the user's logo screen.
You can select a photo, graphic, or company logo as the user's logo, which is
useful in identifying the projector's owner to help deter the. You can prevent
changes to the user's logo by setting up password protection.
•
If yo
u turned on Menu Protection for the User's Logo setting, set it to
O before performing the steps here to save the user's logo.
•
When you copy the menu settings from one projector to another using
the batch setup feature, user's logo is also copied. Do not register the
information that you do not want to share between multiple projectors
as a user's logo.
•
You cannot save content that is protected by HDCP.
•
When Content Playback is set to On, you can display the user's logo
only when the projector starts up.
a
Display the image you want to project as the user's logo.
b
Press the [Menu] button, select the M
anageme
nt menu, and press [Enter].
c
Select User's Logo > Start Setting and press [Enter].
You see a prompt asking if you want to use the displayed image as a user's
logo.
Adjustments such as Geo
metry Correction, E-Zoom, Aspect,
Scale, or Screen Type are temporarily canceled when you select
User's Logo.
d
Select Y
es and press [Enter].
Depending on the current image signal, the screen size may change
to mat
ch the resolution of the image signal.
Saving a User's Logo Image
112
To Next Page
Loading...
