•
If yo
u assigned an ID number to the projector to operate multiple projectors
from the remote control, you may need to check or change the ID setting.
•
Press the 0 (zero) button on the remote control while holding down the
[ID] button. By selecting 0 on the remote control, you can operate all of the
projectors regardless of the projector ID settings.
•
If you lose the remote control, you can order another one from Epson.
g
Related Links
•
"Installing Batteries in the Remote Control" p.41
•
"Remote Control Operation" p.42
•
"Selecting the Projector You want to Operate" p.118
•
"Projector Installation Settings - Installation Menu" p.195
Solutions to Password Problems
If you cannot enter or remember a password, try the following solutions:
•
If you have entered an incorrect password too many times and see a message
displaying a request code, write down the code and contact Epson for help.
Provide the request code and proof of ownership for assistance in unlocking
the projector.
•
If you lose the remote control you cannot enter a password. Order a new one
from Epson.
Attention
If yo
u perform Reset All or Reset Network Settings in the projector's menu, all of
the passwords that have been set for the Network menu are also reset and you need
to set them again. To prevent the passwords from being reset by unauthorized users,
set Network to On in the Menu Protection menu.
Solution When "The Battery that Saves Your Clock
Settings is Running Lo
w" Message Appears
If the message e batt
ery that saves your clock settings is running low. is
displayed, contact Epson for help.
Solving Projector or Remote Control Operation Problems
254
To Next Page
Loading...
