a
Press the [Menu] button, select the Net
work menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
To identify the projector over the network, select Pro
jector Name and
enter a name up to 16 alphanumeric characters long.
d
Set the Priority Control Interface setting to Wired LAN.
e
Se
lect the Wired LAN menu and press [Enter].
f
Assign the IP settings for your network as necessary.
•
I
f y
o
ur network assigns addresses automatically, select IP Settings to set
the DHCP setting to On.
•
If you must set addresses manually, select IP Settings to set the DHCP
setting to O, and then enter the projector's IP Address, Subnet Mask,
and Gateway Address as necessary.
g
To prevent the IP address from being displayed on the network
infor
mation screen, set the IP Address Display setting to O.
Wired Network Projection
138
To Next Page
Loading...
