Epson EB-810E - Page 215

Setting Options Description
Notied IP Addres
s Various IP
addresses
Enter the IP address to receive the
projector's operating status when the
PJLink notication function is enabled.
Enter the addresses using 0 to 255 for
each address eld.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255 (where
x is a number from 0 to 255).
SNMP On
O
Set to On to monitor the projector
usin
g SNMP. To monitor the projector,
you need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
Trap IP Address 1
Trap IP Addr
ess 2
Various IP
addresses
Enter up to two IP addresses to receive
SNMP notications, using 0 to 255 for
each address eld.
Do not use these addresses: 224.0.0.0
through 255.255.255.255 (where x is a
number from 0 to 255).
Community Name Up to 32
alph
anumeric
characters
(do not use spaces
and any symbols
other than @)
Enter the SNMP community name.
You must set the Community Name
when using the SNMP function for the
rst time.
AMX Device
Disco
very
On
O
Set to On when you want to allow the
projector to be detected by AMX Device
Discovery.
Setting Options Description
Crestron
Conn
ected
On
O
Set to On only when monitoring or
controlling the projector over the network
using Crestron Connected.
Enabling Crestron Connected disables
the Epson Message Broadcasting feature
in the Epson Projector Management
soware.
Password Up to 20
alph
anumeric
characters
Enter a password to enable Crestron
Connected. No password is set by
default.
Crestron XiO
Cloud
On
O
S
et to On to monitor or control your
projector and other devices over the
network using the Crestron XiO Cloud
service.
Control4 SDDP On
O
Set to On to allow device information
to b
e acquired using Control4 Simple
Device Discovery Protocol (SDDP).
Art-Net On
O
Set to On when you want to control the
pr
ojector using Art-Net.
•
Net: enter a number for the projector's
Net using 0 to 127 (default is 0).
•
Sub-Net: enter a number for the
projector's Sub-Net using 0 to 15
(default is 0).
•
Universe: enter a number for the
projector's Universe using 0 to 15
(default is 0).
•
Start Channel: enter the start channel
that handles Art-Net using 1 to 495
(default is 1).
Projector Network Settings - Network Menu
215