c
Press the [Menu] button, select the Init
ial/All Settings menu, and press
[Enter].
d
Select Firmware Update and press [Enter].
e
Select Yes to start the rmware update.
Do not disconnect the power cord from the projector while the
rmwar
e is updating. If the power cord is disconnected, the
projector may not start correctly.
All of the projector's indicators turn on and the projector enters rmwar
e
update mode. e computer recognizes the projector as a removable disk.
f
On the computer, copy the rmwar
e le to the root folder (highest folder
in the hierarchy) of the removable disk.
•
Do no
t copy any other les or folders to the removable disk.
Otherwise, the les or folders may be lost.
•
e projector turns o automatically if the USB cable or the
power cord are disconnected before the rmware le can be
copied to the removable disk. If this occurs, perform the
procedure again.
g
Perform the steps to safely remove a USB device from the computer and
di
sco
nnect the USB cable from the projector.
All of the projector's indicators start ashing and the rmware update
starts. When the update nishes normally, the projector enters standby
status (only the power indicator is lit blue). If Direct Power On is set to
On in the projector's Operation menu, the projector turns back on again.
When the update nishes, check the Information menu in the projector's
Management menu to make sure that the Version information has been
updated to the correct rmware version.
•
When al
l indicators ash rapidly, the rmware update may have failed.
Disconnect the power cord from the projector, and then reconnect it to
the projector. If the indicators continue to ash even aer reconnecting
the power cord, remove the power plug from the electrical outlet and
contact Epson.
•
If no operations are performed for 20 minutes in update mode, the
projector turns o automatically. If this occurs, perform the procedure
again.
Updating the Firmware
241
To Next Page
Loading...
