f
Use the arrow buttons to select the area of the image you want to adjust.
en pres
s [Enter].
To reset the Quick C
orner corrections, hold down [Esc] for about 2
seconds while the area selection screen is displayed, and then select
Yes.
g
Press the arrow buttons to adjust the image shape as necessary.
T
o ret
urn to the area selection screen, press [Enter].
•
You c
an also select the area by pressing the following numeric
buttons on the remote control:
•
[1] selects the upper le area.
•
[3] selects the upper right area.
•
[7] selects the lower le area.
•
[9] selects the lower right area.
•
If you see this screen, you cannot adjust the shape any further in
the direction indicated by the gray triangle.
h
Repeat steps 6 and 7 as needed to adjust any remaining corners.
i
When you are ni
sh
ed, press [Esc].
e Geometry Correction setting is now set to Quick Corner in the projector's
Installation menu.
Image Shape
64
To Next Page
Loading...
