Storing and Using Presets 249
Exclude From Record - output is not recorded into any other record target.
Exclude From Grandmaster - content cannot be mastered by a grandmaster.
Exclude From InhibitiveSub - content cannot be mastered by an inhibitive submaster
Exclude From Solo - content will ignore solo. See Fader and Button Configuration (on
page285)for more information on solo.
Channel and Parameter Filters
Channel and Parameter Filters can be used to allow only specified data to be played back. These are
playback filters, and do not impact how data is recorded.
Tap or click on {Chan Filter} to assign channels or groups. Tap or click on {Param Filter} to open a list
of available parameters that you can filter.
When a filter has been applied, an indicator will display in the fader ribbon. C will display for channel
filter, and F is for parameter filter.
Press the red [X] to clear the channel or parameter filters listed.
Fader and Button Configuration
Click or tap on the virtual buttons or fader to see a list of available configuration options.
Button Options
The following options are available for fader buttons:
Bump - plays back the content at 100% of the recorded level. It will continue to do so until
released, unless the fader has a time assigned or the {Hold} property set.
Group/Assert - selects all the channels associated with the fader, if the fader is inactive. If act-
ive, the contents of the fader will be asserted.
Assert - regains control of all of the channels associated with the fader.
Group Select - selects the channels stored in the fader. This is the same as [Group] [Sub] [n].
Freeze- halts all effect activity on the fader.
Off - removes the content and if the fader is set to Master, the fader will remain where it cur-
rently is.
Release - removes the content and if the fader is set to Master, the fader will reset to 0.
Start Stop Effect -starts the effect while ignoring dwell times. Will stop effects if any are run-
ning.
Button Disabled - no action is assigned to the button.
To Next Page
Loading...
Need help?
General
