94 Eos Family Operations Manual
Note: The setting of the manual time master is ignore unless turned on. Changing the
manual timing master will not impact any manual changes already in motion.
The fader ribbon will display the label of M Time to indicate a manual time master fader.
Note: Channel and parameter filters can be assigned to a manual time master.
You can override a manual time master by using a command line entered sneak time.
Master Only
Master Only is a fader option that can be assigned in the fader configuration display (Tab 36) or in
the fader list (Tab 35) for submasters, presets, and palette faders. Submasters can also be configured
in the Submaster List (Tab 15).
Master Only faders are used to set a level for content to fade to. The slider can be used to live adjust
levels when the fader has been activated via the bump button.
Master Only faders default to Full.
To set the fader level from the command line, use [Fader] [n] [At] [level] [Enter].
Note: If content is set to proportional, Master Only fades all content to the setting of the
fader when bumped. If set to I-Master, the fader masters the intensity, but non-intensity
goes to the end state in time when the content is triggered.
Channel and Parameter Filters on Faders
Channel and Parameter Filters can be used to allow only specified data to be played back. These are
playback filters, and do not impact how data is recorded.
Channel and Parameter Filters can be associated with the following targets for playback:
Cue lists
Submasters
Presets
Palettes
Note: Channel and Parameters filters can also be used with Global Effects Faders. See
Global Effects Fader (on page354)
Note: For presets and palettes, channel and parameter filters can only be assigned in the
fader configuration display (Tab 36) or in the fader list (Tab 35).
For cue lists and submasters, channel and parameter filters can be set in the following areas:
Cue List Index
Submaster List
Fader configuration display (Tab 36)
To Next Page
Loading...
Need help?
General
