Setup 145
Display Fader Ribbon
When enabled, the fader ribbon will display. The fader ribbon shows the state of Element's
faders. When disabled, the fader ribbon will not display. {Display Fader Ribbon} is enabled by
default.
Display Help Prompts
When enabled, Element displays help prompt above the command line. When disabled, the
prompts will not display. {Display Help Prompts} is enabled by default.
Trackball Settings
This screen allows you to select various trackball options.
Swap Pan/Tilt
This touchbutton swaps the directions for Pan and Tilt on a trackball. The default for Pan and Tilt
is X and Y, respectively. When this button is enabled, Pan and Tilt will be Y and X.
Reverse Pan
This touchbutton reverses the direction of Pan.
Reverse Tilt
This touchbutton reverses the direction of Tilt.
Reset
This button resets all three trackball settings back to their default.
Brightness Settings
This screen on Element allows you to adjust the light level for desk lamps, and the direct select
brightness.
Desk Lamp
Desk lamps, such as Littlites, can be dimmed from within the software application. The {Desk
Lamp} slider has a range of 0% (dimmest) to 100% (brightest). The default setting is 0%. The
console will set the desk lamp to this setting on startup of the application.
The desk lamps can also be controlled by holding down [Displays] and rolling the level wheel.
Direct Selects Brightness
Use this slider to adjust the color coding of direct selects, as well as the color swatches of color
palette direct selects.
To Next Page
Loading...
