416 Eos Family v2.9.0 Operations Manual
Backup Automatically Takes Control
Switches to the backup automatically if the primary should go offline.
Allowed Output Addresses
A range or ranges of addresses that can be assigned to limit the number of output addresses.
The default setting is to allow addresses 1 through 32767488.
Interface Protocols
MultiConsole
Clicking in the enable box will allow for multiconsole communication on the selected port. See
Multi-console and Synchronized Backup (on page393)
.
Network Type
This setting adjusts the timeout period before a backup device will take control from the master.
Standard- After five seconds of no response from the master, the backup will assume the
master has disconnected and will then take control.
Engineered - After 1.6 seconds of no response from the master, the backup will assume
the master has disconnected and will then take control.
File Transfer
This settings adjusts the show file transfer speed between devices. The default setting is Fast File
Transfer.
Note: If you are experiencing connection issues between devices, you can change the
setting to Normal File Transfer for a slower transfer speed.
Enable Sensor/ FDX3000 Feedback
Clicking in the enable box will allow your console to receive feedback over the network from a
CEM+, a CEM3, or FDX3000. This option is “Enabled” by default. See
[About] Address (on
page325)
for more information.
RDM
RDM can be enabled to allow Element to perform RDM functionality including device discovery
for each ethernet port on a console. By default, RDMis enabled.
See
{Patch} Display and Settings (on page104)
and
[About] Address (on page325)
for more
information.
Note: RDM requires use of a Net3 or Response Gateway. Net3 Gateways must be
using version 5.1 or higher.
FDX2000 Feedback
Clicking in the enable box will allow your console to receive FDX2000 dimmer feedback over
the network.
Broadcast Type
Directed Broadcast - Broadcast packets are directed to a subnet based on the IP address
and subnet mask of the sender.