Show Control 463
Example:
Velocity 127, Threshold 0, box checked – The console is looking for an incoming
MIDI note with a velocity of 127 (7F). The threshold is ignored.
Velocity 127, Threshold 0, box unchecked – The console is looking for an
incoming MIDI note with a velocity that is greater than or equal to 0. The velocity
is redundant, as 127 is greater than 0.
Velocity 127, Threshold 50, box checked – The console is looking for an incoming
MIDI note with a velocity that is greater than or equal to 50
Velocity 127, Threshold 50, box checked – The console is looking for an incoming
MIDI note with a velocity that is greater than or equal to 50 (hex 32)
Velocity 1, Threshold 50, box checked – The console is looking for an incoming
MIDI note with a velocity that is greater than or equal to 50 (hex 32). If the note
with a velocity of 1 is received, the event will also fire as it matches the velocity
parameter.
Velocity 0, Threshold 50, box checked - The console is looking for an incoming
MIDI note with a velocity that is greater than or equal to 50 (hex 32). If the note
with a velocity of 0 is received, the event will also fire as it matches the velocity
parameter.
Velocity 0, Threshold 0, box checked – The console is looking for an incoming
MIDI note that has a velocity of 0. Threshold is ignored.
Program Change Events
Program Change commands typically represent a change in the MIDI voice or instrument type
that should be used for a particular MIDI channel. Similar to MIDI Note commands, the MIDI
data that is expected to be received is shown in the CIA and changes as you select event
parameters. When finished configuring the program change event, press {OK} to store the
event. Otherwise, press {Cancel} to undo the changes.
Message Structure
Program change messages have the structure CN XX, where N represents the MIDI channel
number and XX represents the program number.
Options
The following options are available:
{Channel}
This should match the MIDI Channel for the note command (1-16, 0-F). If set to Any, the console
will respond when any MIDI channel is sent a note command.
To Next Page
Loading...
