ETC Element - Page 487

Show Control 475
OSC Method Arguments Examples/Comments
(defaults to Coarse mode, but
wheel mode can be changed with
the /eos/wheel command below)
/eos/wheel/<index>
number for wheel
mode: 0=coarse, 1=fine
/eos/wheel=1.0
Parameter wheels and encoders
/eos/wheel/<parameter>
number for wheel ticks
(positive or negative)
/eos/wheel/pan=1.0
/eos/wheel/<parameter 1>/
<parameter 2>/...
number for wheel ticks
(positive or negative)
/eos/wheel/pan/tilt=1.0
/eos/wheel/fine/<parameter>
number for fine wheel
ticks (positive or
negative)
/eos/wheel/fine/pan=1.0
/eos/wheel/fine/<parameter 1>/
<parameter 2>/...
number for fine wheel
ticks (positive or
negative)
/eos/wheel/fine/pan/tilt=1.0
/eos/wheel/course/<parameter>
number for coarse
wheel ticks (positive or
nega tive)
/eos/wheel/coarse/pan=1.0
/eos/wheel/course/<parameter
1>/
<parameter 2>/...
number for coarse
wheel ticks (positive or
negative)
/eos/wheel/coarse/pan/ tilt=1.0
Switch
Note: Switch is a variant of Wheel with the added functionality of continuously
repeating wheel ticks until a subsequent OSC switch command sets the wheel ticks to
zero.
This may be used to continuously tick a wheel while a button is held down, for
example. The expected argument range is -1.0 to 1.0, which affects the tick rate
accordingly, but can be a smaller or larger range for more subtle or rapid movement.
OSC Method Arguments Examples/Comments
Switch/Wheel Level
/eos/switch/level X level wheel ticks
/eos/switch Set OSC wheel mode 0 = Course, 1 = Fine
Switch Mode Output – see Implicit OSC Output (on page489) for more information
/eos/out/switch Current OSC wheel mode /eos/out/switch=1.0
Swich/Wheel and Encoder Levels
/eos/switch/<parameter>
X OSC wheel mode ticks for specified
parameter (ex: pan)
/eos/switch/<parameter 1>/
<parameter 2>/...
X OSC wheel mode ticks for specified
parameters (ex: red, green, blue)
/eos/switch/fine/<parameter>
X fine wheel ticks for specified
parameter (ex: pan)
/eos/switch/fine/<parameter 1>/
<parameter 2>/...
X fine wheel mode ticks for specified
parameters (ex: red, green, blue)
/eos/switch/course/<parameter>
X course wheel ticks for specified
parameter (ex: pan)