ETC Element - Page 488

476 Eos Family v2.9.0 Operations Manual
OSC Method Arguments Examples/Comments
/eos/switch/course/<parameter
1>/
<parameter 2>/...
X course wheel mode ticks for
specified param- eters (ex: red,
green, blue)
Active Parameters
Note: The parameter <index> is a 1-based index referencing the list of current
parameters for the selected channel(s).Eos will send the parameter name and current
value for each active parameter, so that the wheels on your OSC-enabled device may
be labeled appropriately.
OSC Method Arguments Examples/Comments
Wheel
/eos/active/wheel/<index>
number of wheel ticks
for the specific wheel
mode (positive or nega-
tive)
/eos/active/wheel/1=1.0
(increase value)
/eos/active/wheel/1=-1.0
(decrease value)
/eos/active/wheel/1=4.0
(increase value rapidly)
(defaults to Coarse mode, but
wheel mode can be changed
with the /eos/wheel command)
/eos/active/wheel/fine/<index>
number of fine wheel
ticks (positive or nega-
tive)
/eos/active/wheel/fine/1=1.0
/eos/active/wheel/course/<index>
number of coarse wheel
ticks (positive or nega-
tive)
/eos/active/wheel/coarse/ 1=1.0
Switch
/eos/active/switch/<index>
number of wheel ticks
for the specific switch
mode (positive or nega-
tive)
/eos/active/switch/1=1.0
(increase value)
/eos/active/switch/1=-1.0
(decrease value)
/eos/active/switch/1=4.0
(increase value rapidly)
/eos/active/switch/1=0.25
(increase value slowly)
(defaults to Coarse mode, but
wheel mode can be changed