ETC Element - Page 489

Show Control 477
OSC Method Arguments Examples/Comments
with the /eos/ switch command)
/eos/active/switch/fine/<index>
number of fine wheel
ticks (positive or nega-
tive)
/eos/active/switch/fine/1=1.0
/eos/active/switch/coarse/<index>
number of coarse wheel
ticks (positive or nega-
tive)
/eos/active/switch/coarse/ 1=1.0
Active Wheel Data Sent by Eos - see Implicit OSC Output (on page489) for more information
/eos/out/active/wheel<number>
2 arguments:
String with parameter
name and current value
from first channel
/eos/out/active/wheel/1=
”Intensity”, 100
Subscribe to Specific Parameters
Once subscribed, Eos will reply with an OSC packet per parameter as they change.
For Example:
•
/eos/out/param/pan
See Implicit OSC Output (on page489) for more information.
OSCMethod Arguments Examples/Comments
/eos/subscribe/param/<parameter>
1=subscribe, 0=u-
unsubscribe
/eos/subscribe/param/red=1
/eos/subscribe/param/<parameter 1>/<-
parameter 2>/...
1=subscribe, 0=u-
unsubscribe
/eos/subscribe/param/pan/tilt=1
Direct Selects
OSC direct selects are virtual buttons and are mapped separately than direct selects visible on
the console. To use direct selects, you must first send one of the direct select creation
commands. Direct selects are mapped as a single target type.
Note: Eos will send the description and button labels for all OSC direct selects. See
Implicit OSC Output for more information.
OSC Method Arguments Examples/Comments
Direct Select Creation
/eos/ds/<index>/<target
type>/
<button count>
/eos/ds/1/chan/10 (create OSC
direct select bank #1 with 10
channel
buttons)
/eos/ds/2/group/25 (create
OSC direct select
bank #2 with 25 group but-
tons)
/eos/ds/<index>/<target
type>/ flexi/<button count>
/eos/ds/1/chan/flexi/10 (create
OSC direct select bank #1 with
10 channel buttons, in flexi
mode)