536 Eos Family v2.9.0 Operations Manual
[Tab] & [Left/Right Arrow] - move displays.
[Tab] & [number] - open or focus specific displays.
[Flexi] & [.] - turns on Flexi multicells off mode. Press again to turn off.
[About] & [Live] - displays the DMX values.
[About] & [Mark] - displays the mark cue used by the channels.
[About] & [Next]/[Last] - displays the next cue that the channels move in or the last cue
that the channels moved in.
[About] & [Park] - displays the parked levels.
[About] & [Part] - displays the cue part number for each parameter.
Facepanel
[Shift] & [Escape] - to lock and unlock face panel.
Encoder Paging Keys & [Number] - pages to the desired encoder control page.
[Escape] & Encoder Paging Keys - locks the encoders. Press any encoder page button to
unlock.
[Flexi] & Encoder Paging Key - to invoke flexi encoder states.
[Fader Controls] & [Bump Button] - select a fader page on wings.
[Fader Page] & Rate Wheel - rolls the selected fader page. (Ti/Eos/Gio)
[Fader Page] & [number] - select a fader page on integral faders. (Ti/Eos/Gio)
[Fader Page] - increments the fader page by 1.(Ti/Eos/Gio)
[Shift] & [Fader Page] - decrements the fader page by 1. (Ti/Eos/Gio)
[Learn] & [Load] - opens the selected fader's configuration tools.
[Off] & [Load] - releases control of content, restoring to background and leave cue list with
pending cue in tact.
[Release] & [Load] - releases control of content, restoring to background, and resets cue
list to top.
[Shift] & [Go] or [Shift] & [Back] - cuts the pending cue or the previous cue.
[Shift] & [Load] - to remove content from a fader.
Operations
[At] [Enter] - removes move information from selected channel/parameters.
[At] [At] - set to Level (as defined in Setup).
[Color] (Encoder Paging Key) & Encoder Movement - hold Color Point while adjusting
parameters.
[Copy To] [Copy to] - posts Move To on the command line.
[Full] [Full] - sets selected channels intensity to “full” and self terminates.
[Label] [Label] - appended to a record target command, clears the current label, this
includes show file labels.
[Recall From] [Recall From] - posts Recall From Cue to the command line.
[Record] [Record] - posts Record Only to the command line.
[Select Active] [Select Active] - Select Active minus submaster contributions.
[Shift] & [Select Active] - posts Select Non-Sub Active.
[Select Last] - repeats last command line, unterminated; does a loop of last five
commands.
[Shift] & [At] - recalls last channel(s) and parameters without terminating; does a loop of
last five commands.
[Shift] & [Enter] - reselects the last command and leaves it unterminated; does a loop of
last five commands.
[Shift] & [Block] - posts Intensity Block to the command line.
[Shift] & [Clear] - clears the command line.
[Shift] & [Delay] - posts follow.
To Next Page
Loading...
