ETC Element - Page 549

Facepanel Shortcuts 537
•
[Shift] & Encoder Paging Key - posts the category to the command line. For beam
subcategories, press Image, Form or Shutter twice to post Beam. (Ion/Gio)
•
[Shift] & Encoder Movement - accesses fine mode.
•
[Shift] & Encoder Push/ Toggle - posts the parameter to the command line. (Ion)
•
[Shift] & Gel Tile - cycles through three modes of Brightness.
•
[Shift] & [Full] or [Shift] & [Out] - flash on or flash out.
•
[Shift] & [+] or [Shift] & [-] - +% or -%.
•
[Shift] & [Highlight] - appends highlight to the current channel selection.
•
[Shift] & [Parameter] - from the encoder controls, posts the parameter to the command
line.
•
[Shift] & [Select Last] - posts additional channel selection options to the softkeys.
•
[Shift] & [Sneak] - makes manual data unmanual.
•
[Shift] & [Update] - shortcut to Save.
•
[Shift] & restore manual faders - reset faders to zero without asserting control.
•
[Shift] & [Direct Select] - posts DS to the command line without terminating.
•
[Sneak] [Sneak] - releases NPs of selected channels and self terminates.
•
[Timing Disable] & [Go] or & [Back] - cuts the next cue or cuts the last cue.
•
[Thru] [Thru] - [Thru] command accesses only channels displayed in the current flexi-state
(unless the range specified is NOT in the current display). [Thru] [Thru] selects the range
regardless of the flexi mode.
•
[Trace] [Trace] - forces a previously inactive light to track its new intensity setting
backwards.
•
[Undo] - clears an unterminated command line. Otherwise opens undo controls.
•
[Update] & [Sub Bump] - to update a specific submaster.
•
[n] [At] [/] [/] [m] [Enter] - sets direct DMX value (m) for channel (n).
•
[Shift] & [Delay] [Delay] - posts hang to the command line.
•
[Shift] & [About] - opens a command line search window.
•
[Shift] & [.] - posts master only to the command line. This is for use with multicell fixtures.
•
[.] - posts cells only to the command line when used after channel number(s). This is for
use with multicell fixtures.
•
[Shift] & [Int Palette] - posts preset on the command line. (Element)
•
[Displays] & [Record] - puts a marker in the log file.